Graco SnugRide 1778253 User Manual
Page 34
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
I o
You must carefully follow the Instructions provided by your
vehicle manufacturer, In addition to the Information In this
manual. Before proceeding be sure you have read and
understood section 6,
“Choosing an Appropriate Vehicie Seat
Location” on
pages 27-32.
Refer to your vehicle owner’s manual and the Instructions
In “6.2.2 SAFE Vehicle Belt Systems”, page 30-32, on tightening
your vehicle belt when using the Infant restraint without base.
Make sure the buckle tongue goes Into the
correct buckle
O.
The seat belt should not
be twisted or turned.
If a front passenger seat Is used (see air bag warning, page 8),
slide the vehicle seat rearward as far as possible from the
dashboard. If a rear seat Is used, make sure the seat In front
of It Is moved forward enough and Is upright enough
to allow room for the Infant restraint.
7.1 Installing the Infant Restraint Without Base
Using Vehicle Belt
1. Place the Infant restraint without base In a rear-facing
position In a vehicle seat.
2. Thread the vehicle belt under both vehicle belt hooks:
34