Uniden UBC3000XLT - Manual (Page 34)

Jsing Search Delay
3n some two-way channels there might be
short lapses in the signal before a reply. The
Search Delay feature causes the scanner to
wait two seconds after the end of a
jansmission before resuming searching, in
case there is a reply.
Unlike Scan Delay, you don't have to turn
on Search Delay for each frequency in the
search range. Search Delay works for the
entire frequency range you chose.
To turn on Search Delay:
C03C*w} ® @ @
Press —
S'® gi’®"®”
В в о“"®” ©
DATIC Dir IRCH a
Ш888.8в8
■ KHl Nn
Press DLY again, to turn off Search Delay.
Locking Out Frequencies
Note: This feature is similar to locking out a
programmed channel, except you can only
lock out 50 frequencies. You can lock out
any number of channels.
During a search, you might repeatedly
encounter frequencies that you are not
interested in. Also, all scanners are subject
to receiving internally generated frequencies
(called birdies) that stop your scanner’s
search when there is no real signal present.
See “UBC3000XLT Birdies" on Page 43,
In either case, you can lock out up to 50
such frequencies to make your scanner
search more efficiently. If you try to lock out
more than 50 channels, the 51st channel
replaces the first channel in memory.
Locking Out a Frequency
When the scanner stops on a frequency you
want to lock out:
Searching resumes immediately.
30