Ch 3h – Uniden UBC3000XLT User Manual
Page 15
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
5. Store the frequency.
The channel number stops flashing and
a beep sounds.
If the frequency is stored in another
channel, you hear a beep and the other
channel appears in the display.
BANK 1
P /
CH
3H
1L9 ICHI
HFH
Further press ^ to store the frequency in
the selected channel, or press
0
twice to
cancel.
Repeat these steps to program more
channels.
Use the banks to store similar frequencies
{e.g., local police frequencies) together.
This helps the UBC3000XLT scan faster.
Notes;
■ If you make a mistake, press 0
twice and start over.
■ If you enter an invalid frequency, a
beep sounds and ERROR appears.
Repeat Step 4.
Automatic Battery Save
If you let the UBC3000XLT sit Idle while you
are programming channels (as you look up
more frequencies, for example), the scanner
may switch to the Battery Save Mode. The
display does not change.
To conserve batteries, the UBC3000XLT
switches to Battery Save when:
■ In Manual Mode
■ Delay is OFF
■ No signal is received for 60 seconds
11