Uniden UBC3000XLT - Manual (Page 29)

I. Select the new channel.
For more Information, see
- 'The Manual Mode" on Page 32
- "The Scan Mode" on Page 20
Note: If you use the Scan Mode to select
the channel, press (»miiiinlto enter the
Manual Mode before proceeding to Step 2.
3. Change the new channel to Priority.
You hear two beeps and P appears at
the left of the display.
Using Scan Delay
On some two-way channels there might be
short lapses in the signal while waiting for a
reply.
The Scan Delay feature causes the scanner
to wait two seconds after the end of a
transmission before resuming scanning, in
case there is a reply.
See also “Using Search Delay" on Page 30.
You must individually program each channel
you want to use Scan Delay feature.
■ After programming a new channel:
25