The scan mode, The manual mode, 8b6 5crn – Uniden UBC3000XLT User Manual
Page 24
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
The Scan Mode
Begin Scanning
There are two ways to begin scanning.
■ Turn on the scanner. Scanning begins
each time you turn the UBC3000XLT on.
■ While in the Manual Mode:
BUiK 11»
SCAN
Mmi
8B6 5CRn
In the Scan Mode, the UBC3000XLT cycles
through all the channels you have
programmed in the banks that are currently
active.
For more information see
- “Scanner Basics" on Page 7
- “Programming Channels" on Page 10
- Turning Banks On or Off” on Page 20.
The soanner stops on each channel that is
broadcasting a signal and automatically
resumes scanning when the signal stops.
Or, you can press i*sc«n) to resume
scanning.
iiHK
"“AN
50
.
12.5 KNiAK
For more information see
- “Using Scan Delay" on Page 25
- "Using Data Skip" on Page 34
Turning Banks On Or Off
After you have programmed channels in
several of the scanner’s banks you can
customise which channels you scan by
turning the banks on or off.
1.
20