5crh – Uniden UBC3000XLT User Manual

Page 28

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Using Priority Scan

You can program one Priority Channel in each

of the first 10 banks. During Priority Scanning,

your seiner checks these special channels
every two seconds, whether or not the
scanner has located an active channel.

To activate Priority Scanning:

Press---------

^14 15 ^1«

© © ©

S B

©"

©”

®” ©'■ ©’■

Press--------

The scanner begins normal scanning, but if
it detects a signal on a priority channel, it

remains on that channel until the signal

ends. See “Using Scan Delay" on Page 25.

SANK i II

SCAN '

8B8

5CRH

SANK ^14 li

SCAN '' PNi

IRD.BOO

Note: If you have more than one bank
selected that has a programmed priority

channel, the lower channel number has top

priority.

Data Skip is not active in this mode.

Selecting A New Priority Channel

There is one priority channel in each of the

first 10 banks. The scanner is
pre-programmed with the first channel of
each of these banks as a priority channel.

However, you can change the priority

channel to be any other channel within the

bank.

Note: When you select a new priority
channel, the old priority channel
automatically becomes a regular channel,

1. Enter the Manual Mode.