Uniden TR620 User Manual
Tr620
TR620
*Range may vary depending in environmental and/or topographical conditions.
• 8 GMRS / 14 FRS Channels
• Long Battery Life
• Extended Long Range*
• Channel Scan
• Channel Monitor
• Battery Strength Meter
• Call Button
1 Antenna
2 PTT (Push-To-Talk) Button
3 Channel/scan up Key
4 Channel/scan down Key
5 Call Key
6 Speaker
7 Power On/Off Key
8 Volume up/mon (monitor) Key
9 Volume down/mon (monitor) Key
10 Microphone
11 Battery Compartment
Door
12 Channel Indicator
13 Receive Indicator
14 Battery Level Indicator
15 Transmit Indicator
Congratulations on your purchase of the Uniden
TR620 radio. This product is a lightweight,
palm-sized radio. Use it at sporting events to stay
in contact with family and friends, hiking, skiing,
outdoors, or in a neighborhood watch for vital
communication.
PACKAGE CONTENTS
Your package contains the TR620 radio, this
reference guide and a belt clip. You will need to
purchase 3 AAA alkaline batteries in order to
operate the unit.
FCC GMRS LICENSE
The TR620 radio operates on the General Mobile
Radio Service (GMRS) frequencies which
require a Federal Communication Commission
license to operate. For licensing information
and application forms, visit the FCC on-line
at:www.fcc.gov/wtb/uls or call the FCC hotline
at 1-800-418-3676. If you have any questions you
can contact the FCC direct at 1-888-225-5322.
INSTALL THE BATTERIES
Your TR620 radio uses 3 AAA alkaline batteries
for power. We recommend using high quality
alkaline batteries.
To install the batteries:
1) Make sure your radio is OFF.
2) Remove the battery compartment door by
pressing on and sliding the compartment door,
allowing the door to be removed.
3) Install 3 AAA Alkaline batteries (not included)
into the battery compartment. Be certain to
follow the + and – symbols in the compartment.
Installing the batteries incorrectly will prevent the
unit from operating.
4) Replace the battery compartment door by sliding
the door into place.
USING THE RADIO
In order to get the most out of your new radio,
read this reference guide completely before
attempting to operate the radio.
Turning the Radio On and Adjusting the Volume
1) Press and hold the
key to turn the radio ON.
2) To change the volume level press the
volume/mon
▲ or ▼ keys to increase or
decrease the volume level.
3) Press and hold the
key to turn the radio OFF.
Adjusting the Sound (Key Beeps)
Your radio emits a beep each time one of the keys
(except for the PTT button and call key) is pressed.
The sound of the Key Beep will increase or
decrease depending on the volume level setting.
To turn OFF this beep:
Press and hold the call key while turning ON the radio.
To turn ON this beep:
Turn the radio OFF and ON again.
Choosing a Channel
Your TR620 radio has 22 channels you can use to
talk to others. In order to speak to someone, each
of you must be set to the same channel.
To choose a channel:
Press the channel/scan
▲ or ▼ keys to increase
or decrease the channel number displayed.
Channel Scan Feature
Your TR620 radio has a channel Scan feature that
allows you to easily Scan all 22 channels. When an
active channel is detected, the unit will pause on
that channel until the channel is clear. Then after
a 2 second delay, the unit will continue scanning.
Pressing PTT button while the Scan is paused on
a channel will allow you to transmit on that channel.
To turn ON channel scanning:
Press and hold either the channel/scan
▲ or ▼ key. The channel number on the display
will rapidly cycle through the channels.
To turn OFF channel scanning:
Press either the channel/scan
▲ or ▼ key.
Talking on Your Radio
To talk to others using the radio:
1) Press and hold the PTT button and speak in a
clear, normal voice about 2-3 inches away from
the microphone.
While you are transmitting the tx icon is
displayed. To avoid cutting off the first part of
your transmission, pause slightly after pressing
the PTT button before you start talking.
2) When you are finished speaking, release the
PTT button. You can now receive incoming calls.
While receiving, the rx icon is displayed.
SPECIFICATIONS
Channels
8 GMRS / 14 FRS
Operating Frequency
UHF 462.5625-
467.7125 MHz
Power Source
3 AAA Alkaline Batteries
Output Power
500mW Conducted
Battery Life
25 Hours typical
(5/5/90 duty cycle)
Frequency Chart
Ch.
Freq.
Ch.
Freq.
1
462.5625
12
467.6625
2
462.5875
13
467.6875
3
462.6125
14
467.7125
4
462.6375
15
462.5500
5
462.6625
16
462.5750
6
462.6875
17
462.6000
7
462.7125
18
462.6250
8
467.5625
19
462.6500
9
467.5875
20
462.6750
10
467.6125
21
462.7000
11
467.6375
22
462.7250
Transmitting a Call Alert Tone
Your TR620 radio is equipped with a call tone that
will be transmitted when the call key is pressed.
To transmit the call alert tone, press the call key.
The tone will automatically be transmitted for a fixed
length of time.
Auto Squelch Feature
The TR620 is equipped with an automatic squelch
system which shuts off weak transmissions and
unwanted noise due to terrain conditions or if you
have reached your range limit.
Monitor Mode Feature
Your TR620 radio allows you to listen in for weak
signals on the current channel at the press of a key.
To turn ON monitor mode:
Press and hold the volume/mon
▲ or ▼ key.
The rx icon will blink.
To turn OFF monitor mode:
Press the volume/mon
▲ or ▼ key. The rx icon
will disappear.
Automatic Power Save Feature
Your TR620 has a unique circuit designed to
dramatically extend the life of the batteries.
If there is no transmission nor an incoming call within
2 seconds, your radio switches to the Power Save mode.
The radio is still able to receive transmissions in this mode.
Note: If you press either the channel/scan
▲
or
▼ key while the unit is pausing on a
channel, scanning will resume.