Kenwood KR-897 - Manual (Page 18)

^ . ... KHe97/KR-797lErtJ
When recordi ng sound with a recorder component of KENWOOD, synchro recording is possible by setting the INPUT SELECTOR
to select TAPE1 or MD according to the connected component.
Preparation
• Switch the TAPEl display to MO or VtDEOl with the following
operation.'
O
Select TAPEl with the INPUT SELECTOR.
@ Press and hold the AUTO key for more than 2 seconds.
Each press switches the display.
f-----------------------------------------------
I, TAPEl (?;MD — iVIDEOI
To record a music source
The input sources are switched in the following order:
XTUNER (frequency display)
X PHONO
ITAPEI (MD or VIDEO!)
I CD
X VIDE02
• The VtDEOl display can be switched to the display of other input by
using the procedure described in "Preparation" above.
• For the synchro recording with 3 cassette deck and/or MD recorder,
refer to the respective instruction manuals..
• It is no! possible the VIDE01 or MD input to TAPE! because all of these
components should use the same INPUT SELECTOR position.
Copying tape (Tape dubbing TAPE 2-*- TAPE 1)
Lights
□
CTAPE ax f — f J
. JLI
* For copying a tape using a double cassette deck, read the instruction
manual of the double cassette deck.
Copying tape (Tape dubbing TAPE 1
-►
TAPE 2)
^ ■■ '—
O Select TAPE 1 with the INPUT SELECTOR control of the
main unit.
O Play the cassette deck connected to the TAPE 1 jacks and
start recording of the cassette deck connected to the
TAPE 2 jacks.
Regarding TAPE 2 MONITOR
A C3ssette deck or graphic equalizer can be connected to this unit's TAPE 2 MONITOR terminals. If you connect a graphic equalizer, turn the
TAPE 2 MONITOR key ON. !f you connect a 3-head cassette deck* you can monitor the source sound, or the sound being recorded, while
recording. Pressir^g the TAPE 2 MONITOR key lets you compare the recorded sound and the source sound. Refer to the operating manual for
the component you connected for further details.