Coleman 7700 LP Gas Series - Manual (Page 13)

Step
10
13
10-A. Assemble two Rear
Panels to the cart assem-
bly using eight Screws
(TN).
Ц Ц NOTE: The Rear Panels
are identical.
Ц Ц Align the square
holes on the Rear
Panel with the
tabs and push
down to install
the panels.
Ц Ц Tighten all
fasteners.
Hardware shown actual size
(TN)
M6 x 15mm Screw
(8) Qty.
9-B
Align square
holes over
tabs and
push Rear
Panel down.
TN
Step
11
Hardware shown actual size
(TN)
M6 x 15mm Screw
(8) Qty.
(UO)
M6 Locking Hex Nut
(8) Qty.
11-A. Assemble two Door Magnets to the Right Panel with
four Screws (TN) and four Locking Hex Nuts (UO).
Ц Ц Install Four Door Magnets.
Ц Ц Open the door to complete
this step.
Ц Ц Install Rear Panels.
11-B. Assemble two Door Magnets to the Left Panel with
four Screws (TN) and four Locking Hex Nuts (UO).
11-A
TN (x4)
UO (x4)
Front
Door Magnet
11-B
TN (x4)
Front
Door Magnet
UO (x4)
Rear
Panel
10-A
TN (x8)
Rear
Panel
Front