Stitch selector, Stitch length control, Adjusting stretch stitch balance – Kenmore 385.15516 User Manual
Page 38: Reverse stitch control, Stitch selector stitch length control
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
stitch Selector
® Setting mark
(2) Stitch selector
The stitch selector not oniy determines the stitch you
select, but also reguiates the stitch width of zigzag stitch.
NOTE:
To avoid needle or fabric damage, make sure the needle is
up and out of the fabric while selecting a stitch.
Stitch patterns are color-coded to recommended setting
zone at the stitch length control.
ZONES:
Red:
Straight, zigzag and utility stitches
Green: Geometric decorative stitches
Blue:
Built-in buttonhole
Gold:
Stretch stitches
Stitch Length Control
® Setting mark
@ Stitch length control
The higher the number of stitch length control, the longer
the stitch. “ 0 ” means “no feed”. The stitch length control
also has a stretch stitch setting. To select a stretch stitch,
set the control at “ ▼ STRETCH”.
NOTE:
When you select a stitch (Red or Green) or buttonhole
(Blue), make sure that the stitch length control is
NOT
set
at“ ▼ STRETCH”.
Study the red, green, gold and blue zones on the stitch
length control. These are recommended zones of stitch
length and are color-coded to the stitches.
Adjusting Stretch Stitch Balance
In stretch stitch sewing, the stitch length control should be
in the detent position between "S” and “L" ( p o s i t i o n ) for
most materials. Depending upon the type of fabric used,
you may need to adjust this control to match forward
stitches of stretch sewing with reverse motion stitches. To
shorten stretch stitches, turn the control slightly toward “S”.
To lengthen, turn toward “L”.
Reverse Stitch Control
Sewing will be made in reverse while the reverse stitch
control is pressed.
30