Bobbin winding, Bobbin winding -20 – Kenmore 385.15516 User Manual
Page 26
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Bobbin Winding
• Removing bobbin case
Remove the extension tabie from the machine by puiiing
it to the left. Open the shuttle coverCDby puiiing down
the embossed part on the left of the cover.
Raise the needle to its highest position by rotating the
handwheel toward you.
Ci)
Shuttle cover
(2) Bobbin case
To remove the bobbin case® from the shuttle, puli open
the latch of the bobbin case. Pull the bobbin case straight
out of the shuttle.
• Bobbin winding
m Release the clutch by pulling out the handwheel. This
wifi stop the needle from moving while you wind the
bobbin.
[
2
] Draw thread from spool.
I® Guide the thread around the thread guide.
[5 Thread through the hole in the bobbin from the inside to
the outside.
[
5
] Put the bobbin on the bobbin winder spindle.
18