Kenmore 596.50003100 - Manual (Page 7)

Installirig Youf Refrigerator
How to Install and Remove Handles
continued
Removing Front-Mounted Handles
Removing handles may be necessary when transporting unit through tight spaces..
'f M emove bottom portion of
handle trim with a very
small £at-blade screwdriver,
IMPORTANT:
Wrap blade of screwdrivt
1
1 '
O Remove two handle base !•
^ screws, Pall handle up and P
nnC fn rdpufte frnm unit. n.
1
sr it Fit may be tight, 1
......................................................................................................
Removing Full-Length Extruded Handles
Removing handles may be necessary when transporting unit through tight spaces, or installing or replacing decorative panels.
o
r
How to Level Your Refrigerator
Matenals Needed
hex head driver Level
1
M emove toe grille and bottom binge covers
(see previous instmcdons).
Tnrn both &ont adjustment screws
(A) clockwise to raise and q _ ^
counterclockwise to lower, @
f
Turn both rear adjustment
screws (B) clockwise to
raise and counterclockwise
to lower.
Giedc with level to verify tilt to the
back Gar proper door dosute
• If unit is aligned and stable, replace toe grilie
and hinge covers
V.
If required, correct roddng of unit by
turning rear adjustment screw dockwise
f-j-% <3. .1. €..j ./ .j j** ^
If doors are uneveOr.,
• Determine which door needs to be raised.
I Turn front roller adjustment
screw clockwise to raise
front corner of door
If the unit has reached the
limit of its adjustment range,'
and doors are still not level-
lower opposite door by turning roUer
adjustment screw counterciookwise.
Check with level to verify Vi tiit to the back for proper
door closure
If unit is aligned and stable, replace toe grills and
hinge covers