Kenmore 596.50003100 - Manual (Page 13)

Ffeezef Features
CAUTION
To avoid property damage, observe the following:
» Do not force ice maker arm down or up
• Do not place or store anything in loe storage bin.
WARNING
To avoid possible injury, including death, do not place glass
items in Ice cream sheSf Glass objects may shatter or
explode if exposed to extreme cold.
Primary Features
Automatic Dispensing icte Rfliaicer
This Ice maker creates the ice used in the dispensing
system
Using Ice Maker for the First Tims
• Confirm ice bin Is in place
and ice maker arm ts down.
• After freezer section reaches
between 0° to 2°F (-18° to
-17° C), ice maker fitte with
water and begins operating.
• Allow approximately 24 hours after instailaiion to
receive first harvest of ice
• Discard ice created within first 12 hours of operation to
verify system is flushed of impurities.
Operating Instructions
• Confirm ice bin is in place and ice maker arm is down
• After freezer section reaches 0" to 2°F (-18° to -17° C).
ice maker fills with water and
begins operating You will have a
complete harvest of Ice
approximately every 3 hours
• stop ice production by raising ice
maker arm until click is heard
• Ice maker will remain in the off position until arm is
pushed down
Drawers
ice cream shelf provides a space for Items to be
chiSied or frozen quickly
» To remove, lift ice cream shelf
from ice bin rails and pull
straight out
• To instail, fit shelf over lojs of
ice maker and lower onto ice
bucket rails.
Freezer Basket
To remove and instati basket:
• To remove, lift front of basket
and putì out to its full
extension Lift Up front of
basket and remove
• To install, slide basket into rails at bottom of freezer
section Lift up front of basket, and slide to the back of
unit
Poor storage
Door Buckets
• Refer to refrigerator section for instructions
Ice Storage Bin
The ice storage bin Is located below the automatic
dispensing ice maker.
To remove and insiail ice storage bin:
• To remove bln, remove ice cream shelf.
Raise ice maker arm to deactivate ice
maker. Lift front of fain and puli out
to its full extension, Lift up front of
bin and remove.
• To Instail, slide bln into rails below ice maker until bin
locks into place. Drop ice maker arm to activate ice
maker, and replace toe cream shelf.
IMPORTANT: Ice bin must be
locked in proper place for proper
ice dispensing. If freezer door
does not close, bin is not in proper
location Turn auger driver counterclockwise (as shown)
to property align ice bin with back of unit,.
Q
Shelves
Freezer Shelf
To remove and install clip-mounted shelves:
• To remove, pull shelf from wall
mounting clips and pull left side
of shelf out of wall mounting
holes
• To install, place shelf in mounting hole and attach to
wall mounting dips
To remove and install rail-mounted si
' To remove, snap right side of
shelf from cabinet railing and
remove from wall mounting
clips
• To install, replace shelf in
wall mounting clips Be sure back edge of shelf Is
flush witli back of cabinet arsd snap shelf into cabinet
railing
13