Dispenser light not shown, Dispenser pad, Removable tray – Kenmore 596.50003100 User Manual
Page 14: Wafer dispenser operation, Water dispenser operation, Features, Caution
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Features
Dispenser Light
n o t s h o w n
A light activates within the dispenser area at full power when dispensing Ice or water
Dispenser Pad
The dispenser pad is located on the back wall of the dispensing area- When the dispenser
pad is pressed, the selection chosen on your dispenser control panel will dispense.
Removable Tray
The removable tray at the bottom of the dispenser area is desigrsed to collect small spills
and may be easily removed for cleaning and emptying purposes
IMPORTANT: Removable tray does not drain Continuous water running into tray will cause tray to overflow
Wafer Dispenser Operation
CAUTION
To avoid personal Injury or property damagej observe following instructions:
• Do not put fingers, hands, or any foreign object into dispenser opening
• Do not use sharp objects to break Ice
■ Do not dispense ice directly into thin glass, fine china, or delicate crystal.
NOTE: During initial use of water dispenser, there will be a 1 to 2 minute delay while water tank
fills before water dispenses Discard first 10-14 containers of water after initially connecting
refrigerator to household water supply and after extended periods of nonuse.
To use dispenser pad:
• choose water selection from dispenser control panel.
• Press sturdy, wide-mouthed container against dispenser pad. When dispensing crushed ice,
hold container as close to chute as possible to reduce spraying.
• Release pressure on dispenser pad to stop water from dispensing. A small amount of water
may continue to dispense, and collect in dispenser tray Large spills should be wiped dry,