Dispenser operetion, Dispenser lock, Light function – Kenmore 596.50003100 User Manual
Page 16: Filter status iniiicator light, Dispenser features, Electronic control features, Temperatura keys
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Dispenser Features
Electronic Control Features
Dispenser Operetion
To dispense water:
To dispense Ics:
• Select the button,
• Press container against
dispenser pad-
I WATER [ CRUSH
Select the
\j^^j
button for cubed ice
Press the button for crushed ice.
Press container against dispenser pad.
NOTE: If water dispenser is continuously active
for more than 2 minutes, an automatic lod< out
sensor will shut down power to dispenser area-
For instiuctions on how to unlock your dispenser,
see the section entitled “Dispenser Lod<" below.
Dispenser Lock
This feature prevents ice or water from being dispensed
T
0
lock and unlock dispenser:
„
• To lock dispenser, press and hold the fiffl button for 3 seconds, A green indicator light above button confirms
dispenser is locked
To unlock dispenser, hold the
button for 3 seconds. Green indicator light above button will go out
Light Function
The light function offers offers two settings: OFF and AUTO
The OFF setting will turn off the dispenser cavity light.
The AUTO setting allows the
SENSOR
to measure the surrounding light levels and adjust the power of the cavity light
accordingly. When the senser registers lower light levels {night time, darkened kitchen), the cavity light will respond at
50% power, When the senser registere high light levels (lighted kitchen, direct sunlight), the cavity light wifi not activate.
To activate auto setting:
•
Press the button located on contrd^ne),
• To activate the AUTO setting, press the [““J button.
When the green indicator light above the button display
Is on, the cavity dispenser light will use the AUTO setting
NOTE: Dispenser light will operate at full power
when ice or water functions are in use.
To deactivate light;
• Press the UmrJ button located
on
controi pane!. Green
indicator light above button wHS go out.
Filter Status Iniiicator Light
The fitter status indicator light serves as a reminder to replace the water filter, A green light indicates that the
filter is in good condition, A red light indicates the filter should be changed Once tight turns red, It will remain
red until function is reset
To reset indicator:
„
_
light wiil flash 3 times when the function has successfully reset.
FILTER
GOOD O
CHANGE O
.
^ Temperatura Keys
These keys wl!i lower or raise the freezer or fresh food
compartment temperature.
NOTE: See thè sedian How to Adjust thè Temperature
Controls for Instruclions on how lo set food Ctompartment
temparalures.
/\ '
TEMP SET
16