Kenmore 596.50003100 - Manual (Page 20)

Hints and Care
A \ How to Get the
^ J Most Out of
^ Your Energy
Dollar
Avoid overcrowding refrigerator
shelves. This reduces effeciivity of
air circulation around food and
causes refrigerator to run longer.
Avoid adding too much warm food
to unit at one time. This overloads
compartments and slows rate of
cooling
Do not use alunninurri foil, wax
paper, or paper toweling as shelf
liners This decreases air flow and
causes
Unit to run less efficiently,
A freezer that is full runs most
efficientty
Locale refrigerator in coolest part of
room. Avoid areas of direct sunlight,
or near heating ducts, registers, or
other heat producing appliances If
this Is not possible, isolate exterior
by using a section of cabinet or an
added layer of insulation
Refer to this Use and Care Guide
section on temperature controls for
recommended control settings
Clean door gaskets every three
months according to this Use and
Care Guide’s cleaning instructions.
This will assure that door seáis
property and
Unit runs efficientiy
Take time to organize items in
refrigerator to reduce time that door
is open.
Be sure your doors are dosing
securefy by leveling unit as'
instructed in this Use and Care
Guide.
Clean condenser coils as indicated
in the Use and Care Guide every 3
months. This will increase energy
efficiency and cooling performance.
How to Remove and Replace Light Bulbs
WARNING
To avoid eiectrical shock which can cause severe personaJ injury or death,
disconnect power to refrigerator before replacing light bulb- After replacing light
bulb, connect power
To avoid persona! injury or property damage, observe the foiiowing;
• Allow light bulb to cooi
• Wear gloves when replacing light buib.
Upper refrigerator section
1. Locate finger gaps on each side of clear light
shield, insert fingers and press in on each side
of shield Pull shield down and remove
2, Remove light bulbs.
3. Replace with appliance bulbs no greater titan
40 waffs,
4, Replace light buib cover by inserting front tabs of
light shield into slots directly in froni of light assembly.
Lower refrigerator section
t Pinch bottom tabs (A) on light cover and puli straight
out,
2- Remove light bulb,
3 Replace buib with appliance bulb
no greater than 40
watts.
4, insert lop tabs (B) of light cover into liner slots and
snap bottom portion over light assembly
Freezer section
1 Remove tee bin by lifting front of bin and pulling out
2, Remove light bulb cover by pinching top tab (A) and
puiiing cover out.
3 Remove light bulb. Replace with appliance bulb
no greater than 40 watts.
4- Insert bottom tab (B) of light cover into liner slots and snap
top portion over iight assembly
5, Replace ice bin by sliding in until bin focks into place
Ice and water dispenser
1, Locate light bulb iriside top edge of dispenser frame. Unscrew
to re move-
2, Replace light buib with a 7-watt, 120 volt bulb
I
20