Kenmore 596.50003100 - Manual (Page 5)

These Instrucüons were provided to atd you in the installation of your unit
inslaSiation
How to Transport Your Unit
Follow these lips when moving the unit to final location;
• NEVER transport unit on its side if an upright position is not possible, lay
unit on its back Ailow unit to sit upright for approximateiy 30 minutes prior
to plugging unit In to assure oii return to the compressor, Plugging unit in
immediately may cause damage to internal parts,
• Use an appliance dolfy when moving unit ALWAYS track unit from its
side-NEVER from its front or back,
• Protect outside finish of unit during transport by wrapping cabinet in
blankets or inserting padding between the unit and dolly
' Secure unit to dolly firmly with straps or bungee cords. Thread straps
through handles when possible, DO NOT overtighten. Overtightening
restraints may dent or damage outside finish.
How to Select the Best Location
Observe these points when choosing the final location for your unit:
• DO NOT install refrigerator rtear oven, radiator, or other heat source If
that is not possible, shield refrigerator with cabinet material
• DO NOT install where temperature falls below 55T (Î3°C), Malfunction
may occur at this temperature,
• Make sure floor is levei. if floor is not level, shim rear wheels of unit with a
piece of plywood or other shim material.
• To assure proper door closure, verify that the unit is leveled with a %" tilt
to the back-
How to Remove and Install Panels
(some models)
Reference the sheet entitled Decorator Door Panel Installation instructions
shipped on the front of your unit
Installing Your Refrigerator
Sears cannot be responsible for improper
How do I measure an opening
to insure proper fit?
This refrigerator was designed to fit a 69" tail
opening to allow for proper ventilation,
leveling, and door adjustments
Please also take into account, when
measuring space for your unit, that some
models require a certain amount of
clearance around it to allow for proper air
flow Proper air flow is key to keep your unit
running a optimum efficiency To determine
measurements, please reference the table
below.
o
Subflooring or floor coverings (i e, carpet, tile, |___
wood floors, rugs) may make your opening |
smaller than anticipated
■■
Some clearance may be gained by Using the
(0
leveilng procedure under "How to Level Your Wp
Refrigerator".
Unit Total
Volume
Recommended
Clearance
Top Sides Rear
Less Than 23
cu. ft.
N/A N/A N/A
Greater
Than 23 cu. ft.
N/A
Vi”
IMPORTANT: if unit is to be installed into a
recess where top of unit is completely
covered, use dimensions from floor to top of
hinge cap to verify proper clearance