Kenmore 665.72002 - Manual (Page 23)

To Replace: ^ ^
1. Grasp the door on the sides with your fingers on the front of
the door and your thumbs on its inside surface. ::
2. : Hold oven door so that the top edge of each hinge hanger is
: horizontal. Insert hinge hangers into the front frame hinge
slots. , :
3. Tilt top of door toward range. Slide hinge hangers down onto
front frame support pins. Make sure the hinge hangers are
fully seated and engaged on the support pins.
4. Insert the door stop clip with its angular surface at the top of
.. the frame hinge slot, then push in the bottom of the clip until
its flanges are flush with the front frame. ; \ .
5. Open the door completely and remove the door removal pins.
Save door removal pins for future use.
6 . Close the door. .............
storage Drawer
The storage drawer can be.removed. Before removing, make sure
drawer.is.cool, and.empty. .
: : : : : : : :
iQ.Remove: ■ . . ■ . . ■ . . . .^.......... .v ■ ■■...................■■.. '■■■
1. .Pull.drawer straight out to the first stop. ........... "
2. .Lift .up the back of the.drawer and pull out. : : : : : : : : : : : : T : : ; . ;
To Replace; .r---;'" .....
1. Fit the ends of the drawer rails into the guides in the cavity.
2. .Slide the drawer.closed. T \ : : : : : : : : : : : : : : : : : :
Warming Drawer t
Tfon some models)
Remove all items from inside the warming drawer, and allow the
unit to cool completely before attempting to remove the drawer.
To Remove:
Open drawer to its full open position.
Locate the black triangle-shaped tabs on both sides of the
drawer.
3. Press the tab down on the right side, and lift tab up on the left:
.:: side at the same time, then pull drawer out another Inch.
: 4. Holding the drawer by its sides, not its front, carefully pul! it
all the way out. ' ....
To Replace: ....
1, Align the drawer glides with the receiving guides.
Push drawer.in all the way.
Gently open and dose. the drawer to ensure it is
properly on the slides. seated
23