Kenmore 665.72002 - Manual (Page 22)

3 .
4
Push release lever toward bulb. The left end of the light
assembly will raise up.
7. Starter
2. Release lever
3. Bu!b :
To remove starter, turn it counterclockwise and lift out of its
mounting b a s e . : ■ ■: : ;
■ :: ■ ■ ■ T::
S. To remove bulb, roil it forward or backward 90° until it clicks,
■ ■ ■ ■ ■ then lift out, .... :: ........... : ' : -
To Install Starter and/cff Bulb: ^.........
Fit starter prongs into starter mounting base and turn
clockwise.
2 . Slide bulb prongs into bulb mounting base ends. Roll the bulb
forward or backward 90° until it clicks.
::
3. Push down on the left end of the bulb mounting base. Whei
the assembly latches, it will click..................... : : : : : : : f
Replace lens cover. Position the two rear lens cover tabs In
front of the two metal spring clips (located directly behind, the.
bulb). Push back and down on the lens cover to lock into .
position
For normal range use, it is not suggested to remove the oven :
door. However, if necessary, follow these instructions. The oven
door is heavy.
Before Removing:
1. Use a putty knife or screwdriver and insert it at the bottom
corner of the door stop clip,
Pry door stop clip free and remove from front frame hinge
slot..Take care not to scratch finish.
Repeat, procedure fpr other door stop clip.
^Tb-Remove: .... ■- T':
1. Open the oven door. Insert door removal pins, included with
your range, into both hinge hangers. Do not remove the pins
while the door is removed from the range.
: ;
2.
3.
Carefully close the door until it rests against the door remova
■ ■ p i n s . , f T .„ v - - - , ' - - ­
. Grasp the door on the sides with your fingers on the front of
The dopr and your thumbs on the inside surface. : f:
Pull door straight up, then toward you. Hinge hangers will
. slide out of front frame hinge slot. Do not remove door
removal pins.until the door is replaced on the range,
Plug in range or reconnect power.
22