beautypg.com

Foot control, Light/power switch, Setting up your machine – Kenmore 17922 User Manual

Page 4

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

Foot

Pedal lock knob

Fig. 2

1. Install your Kenmore sewing machine in a

Kenmore cabinet, case or set the machine

on a sturdy flat surface.

2. Your Kenmore sewing machine has been

thoroughly oiled at the factory. Be sure to
wipe off the needle plate area and bed
plate carefully before sewing a garment.
It is wise to practice on a scrap of fabric
so any surplus oil is absorbed.

3. FOOT CONTROL

Your

machine

is

supplied

with

an

electronic foot control which enables you
to sew very slowly. Even at low speed you

have extra power for the needle to
penetrate through several thicknesses of

fabric. Faster speeds are also easily

controlled.

1. Pull out the foot control from its

storage position under the free arm.

(Fig. 1)

2. Slide pedal lock knob to the right and

the foot pedal will pop up to its
operating position. Push foot control
plug into the cord receptacle on the
foot control. (Fig. 2)

3.

Push machine plug into the cord

receptacle at the rear side of the
machine.

Then

connect

power-line

plug into any 110-120 volt A . C . wall
outlet. (Fig. 2)

4. LIGHT/POWER SWITCH

Your machine will not operate unless the

light/power switch is turned on. This
same switch controls the machine power,
sewing light and indicator lights on the
stitch indicator panel and electronic

needle control. If you are interrupted or
stop sewing, turn off the switch.

SETTING UP YOUR MACHINE

This manual is related to the following products: