Picking up bobbin thread – Kenmore 17922 User Manual
Page 12
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
1. Raise presser foot lever.
Hold needle thread loosely in left hand
and push needle up/down switch two
times or rotate hand wheel toward you
one complete turn.
PICKING UP BOBBIN THREAD
2. Bring bobbin thread up by pulling upper
thread.
3. Pull both threads under and to the back
of the presser foot, leaving 3 to 4 inches
of thread clear.
If you can not pick up bottom thread by
following above steps, then check:
1. Is needle threaded ?
2. Is thread tangled around needle ?
3.
Is bobbin case threaded correctly with
thread going through slots A and B as
shown on page 9, Fig. 4 and 5 ?
4. Is there 4 inches of thread coming from
bobbin case and through slot of needle
plate as shown on page 9, Fig. 6 ?
5. Is thread from bobbin case tangled ?
11