Stitch selector and indicator, Stitch width/needle position control, Stitch width control – Kenmore 17922 User Manual
Page 14: Needle position control
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
STITCH SELECTOR AND
INDICATOR
1. To select a stitch, be sure needle is out of
fabric at its highest position. Push the
stitch selector in and out to release the
mechanism.
2. Then turn the selector to left or right until
the required stitch is indicated by the red
light on the indicator panel.
STITCH WIDTH/NEEDLE
POSITION CONTROL
STITCH WIDTH CONTROL
The width of all the stitches produced on this
machine, with the obvious exception of
straight stitch, can be made narrower or
wider by adjusting the stitch width control.
To decrease or increase the width of a stitch,
turn the stitch width control dial from 0 - 4 .
The higher the number the wider the stitch.
Recommended setting ranges are indicated
and color-coded with patterns on the stitch
indicator panel.
When sewing with a double needle, do not
use a setting above 2, as indicated on the
dial.
NEEDLE POSITION CONTROL
(Model 17922 only)
This dial is used to change needle position
when
straight
stitching.
Three different
needle positions can be selected: S - standard
position for general sewing, C - center and
R - right.