Threading top thread, Threading double needle – Kenmore 17922 User Manual
Page 11
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
THREADING TOP THREAD
Fig. 1
Fig. 2
1. Raise slotted take-up lever to its highest
position.
Place thread spool onto spool pin. Place
appropriate spool cap over the spool of
thread.
Draw thread through rear thread guide
(A) and into threading channel (B) toward
you. (Fig. 1)
2.
Draw thread down and around check
spring (C) and up through slotted take-up
lever (D). (Fig. 2)
3. Draw thread down into thread guides (E)
and (F). Thread needle from front to back
as shown in Fig. 3.
THREADING DOUBLE NEEDLE
Place second spool of thread on second
spool pin, and thread machine as you would
for a single needle except double thread
guides are provided. Draw one thread
through each of these and through each side
of needle from front to back.