GE JGBP27DEMWW - Manual (Page 44)

Installation Instructions
[U ASSEMBLE SURFACE BURNERS (CONT.)
Grates
Place the left, right and center grates on the cooktop.
These grates are position specific. The undersides of
the left and right grates are marked "LEFT FRONT" and
"RIGHT FRONT." On some models the underside of the
grates ore marked "Outside". Place the middle grate
with its bowed front toward the front of the range.
^CAUTION Do not operate the burner
without all burner parts in place.
Left Front Right Front
H LIGHT THE BURNERS
[ a ] Check Ignition of Oven Burner
The oven is designed to operate quietly and
automatically. To operate the oven, turn the
OVEN CONTROL knob to a setting above 300°F.
The oven burner will ignite and burn until the
set temperature is reached. The oven burner
will continue to cycle on and off as necessary to
maintain the oven at the temperature indicated
by the OVEN CONTROL knob.
Adjust Bake Burner Air Adjustment Shutter
on Models with a Broiler Drawer, if
Necessary
Determine if the bottom burner flames are
B
With the oven bottom removed, properly
adjusted flames should have approximately
1" blue cones and, if range is supplied with
natural gas, should burn with no yellow tipping.
(With most LP gas, small yellow tips at the end
of outer cones are normal.) Flames should
not lift off burner ports. If lifting is observed,
gradually reduce air shutter opening until
flames are stabilized.
The shutter for the oven burner is near the
back wall of the oven and behind the broiler
drawer.
E LIGHT THE BURNERS (CONT.)
IE Adjust Broil Burner Air Adjustment Shutter on
Models with a Broiler Drawer, if Necessary
(cont.)
To Remove the Broiler Drawer:
1. Pull the drawer out until it stops, then push it
back in about one inch.
Loosen air
adjustment
shutter
2. Grasp handle, lift and pull broiler drawer out.
On some models, remove the metal shield at
the rear of the cavity.
To adjust the flow of air to the burner, loosen
the Phillips-head screw and rotate the shutter
to allow more or less air into the burner tube.
Check Ignition of Surface Burners
Operation of all cooktop and oven burners should
be checked after the range and gas supply lines
have been carefully checked for leaks.
Select a top burner knob and simultaneously push
in and turn to LITE position. You will hear a clicking
sound indicating proper operation of the spark
module. Once the air has been purged from the
supply lines, burners should light within 4 seconds.
After burner lights, rotate knob out of the LITE
position. Try each burner in succession until all
burners have been checked.
44