To begin steam clean cycle, Acaution, Using steam clean – GE JGBP27DEMWW User Manual
Page 35: Steam, On some models), Start, Clear
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Using Steam Clean,
(on some models)
GEAppliances.com
ACAUTION
During the steam clean cycle,
the oven bottom becomes hot enough to cause burns.
Wait until the cycle is over (30 minutes) before wiping
the inside surfaces ofthe oven. Failure to do so may
result in burns.
The Steam Clean cycle makes It easier to clean light soil from
the porcelain oven Interior and door glass.
The range should be at room temperature before begin
ning the Steam Clean cycle. Ifthe oven is too hot, "Hot" will
appear on the display and the cycle will not activate until the
oven cools down.
The Steam Clean cycle performs best on new spills or soils.
Burned-on food is more difficuitto remove.
floor.
C
steam |
Clear^
G
Start~^
On
J
G
Clear^
OffJ
To Begin Steam Clean Cycle:
|~^ Remove racks and accessories from the
oven cavity. Do not place cookware or
other items in the oven during the Steam
Clean cycle.
Pour 1 cup (8 oz.) room-temperature
water ontothe recessed area ofthe oven
bottom. Do not add cleaning solutions or
chemicals of any kind to the water. Do not
pour water down the burner slots on oven
bottom.
Close the door.
Press the
Steam Clean
pad; then press
Start/On.
^ A 30-minute cycle will begin to count
down on the display.
When the Steam Clean cycle is complete,
the oven control will beep and the
Steam
Clean
light will blink. Press the
Clear/Off
pad and open the door.
'Y]
The oven bottom and remaining water
will still be very warm at the end of the
cycle. This is normal.
^ Remove soils using a scrub brush or nylon
scouring pad. A soap-filled steel wool pad
may be used only on the porcelain oven
interior.
The use ofabrasive pads will
scratch the doorglass.
Do not wipe soil
or water onto the door gasket.
pi Remove any remaining water with a dry
cloth or sponge.
^ Leave the door open to air dry.
IMPORTANTNOTES:
•
Ifa steam clean cycle is initiated without
water, press the
Clear/Off
pad
to end the
cycle. Wait for the range to cool to room
temperature before pouring water into
the recessed area and initiating another
steam cycle.
• DonotopenthedoorduringtheSteam
Clean cycle. An error beep will sound upon
opening the door.
• Press
Clear/Off
pad
at any time to end the
cycle.
• If mineral deposits remain in the oven bot
tom after cleaning, use a cloth or sponge
soaked in vinegar to remove them.
• Some water may drip from the bottom of
the oven door. Ifthis happens, wipe it up at
the end ofthe cycle.
• Thedoorgasketmaybewetwhenthe
Steam Clean cycle finishes. This is normal.
Do not clean the gasket.
• If soil still remains after cleaning the oven,
see the
Care and Cleaning ofthe Range
section ofthe Owner's Manual for addi
tional options.
35