Pin programming – CLIFFORD AvantGuard 5.1 User Manual
Page 34
31
© 2 0 0 6 d i re c t e d e l e c t ro n i c s — a l l r i g h t s re s e r v e d
pin programming
A PIN code can have one to four digits; each digit can be from 0-9.
Programming Procedure
1.
Enter the feature location in the installer programming grid.
2.
Immediately press and release
of the PlainView 2 Valet
switch.
3.
Select each digit by pressing
1-9 times, and then press
to enter the number into the system. To enter a zero,
press only.
To program a PIN code of 1032:
1.
Press and release
once and
once. You will
hear one chirp.
3.
Press and release
once. You will not hear a chirp
after programming a zero.
5.
Press and release
three times, and then press
once. You will hear three chirps.
6.
Press and release
two times, and then press
once. You will hear two chirps.
4.
Wait for two siren chirps after a five second pause or five
seconds after the last digit has been entered if using less
than four digit code number.
5.
Turn off the ignition; the siren will chirp three times.
6.
The programming mode is now exited.
nnoottee:: A PIN code cannot begin with a zero.