CLIFFORD AvantGuard 5.1 - Manual (Page 14)

11 © 2 0 0 6 d i re c t e d e l e c t ro n i c s — a l l r i g h t s re s e r v e d
Silencing section of this guide.) However, if the alarm completes the full
trigger cycle when disarmed you will hear three chirps.
disarming without a transmitter
This feature allows you to disarm the system without the transmitter
should it be lost, damaged, or disabled. In order to disarm without a
transmitter, you must have the vehicle’s ignition key, know where the
PlainView 2 Valet switch is located, and have the PIN code. Be sure to
check with the installer for the location of the PlainView 2 Valet switch.
Please refer to the Disarm/Valet Mode section of this guide for instruc-
tions to enter the pin code.
remote siren silencing
This system offers remote siren silencing. Remote siren silencing is a fea-
ture that makes it possible to silence and reset the system when it is
triggering without disarming the system. If the system is triggered and
the siren has been sounding, press on the transmitter to stop the
trigger and return the unit to the armed state. This prevents you from
disabling the system should you wish to silence it without visually
checking the vehicle. After resetting the system, press again to
disarm the system.