Carl Goldberg GBGA1092 - Manual (Page 18)

18
7. Mount the rudder control horn the same as
we did with the ailerons and flaps. Mount it
1-1/4” up from the bottom of the rudder and
angled toward the pushrod exit.
8. Mount the elevator servo in the manner, 1-
1/8” over from the inside edge and perpen-
dicular to the hinge line.
9. Install the pushrods in the slots in the rear of
the fuselage. Put a 2mm clevis and silicone
keeper on each rod and connect to the con-
trol horn.
SERVO INSTALLATION
1. Locate the two 3/16”x1/2”x1-5/8” wooden
blocks. Glue in place at the front and rear of
the rudder servo cutout. This will raise the
rudder servo to prevent any interference
between the rudder arm and the elevator
arm.
2. Mount the rudder, elevator,and throttle servo
in the openings provided.