beautypg.com

Radio installation – Carl Goldberg GBGA1092 User Manual

Page 17

background image

17

PUSHROD INSTALLATION

RADIO INSTALLATION

1.

Collect the following items:

(2) 3/8” X 16” wooden dowels
(4) 2mm x 30cm pushrods

(4) Silicone clevis keepers

(4) 1/2” x 1-1/2” shrink tubing
(4) 2mm metal clevis

(2) 2mm x 18cm metal rods
(2) EZ servo connector
(2) 4mm x 20cm nylon tubes
(2) nylon swing in keepers

2.

Take two of the 2mm x 30cm pushrods and

make a 90 degree bend on the unthreaded

end 3/8” long

3.

Take the two 2mm x 18cm rods, unthreaded

on both ends, and make a 90 degree bend in

one end.

4.

Take the two wooden dowels and insert one

long rod and one short in each end. Fit the

3/8” leg in the hole and the wire in the

slot.Apply thick CA glue or epoxy to the wire

and then slide the shrink tubing in place.

Shrink the tubing tight.

5.

Remove the covering over the rudder

pushrod exit on the top-right side of the

fuselage.

6.

Remove the covering over the elevator

pushrod exit on the left-lower side of the

fuselage.