Carl Goldberg GBGA1088 - Manual (Page 8)

8
6. Thread on to one end of a 2-56 x 1-
3/4” pushrod a nut and Golden Clevis.
Mount the pushrod onto the the horn brack-
et.
Thread the other 2-56 clevis and nut on the
other end.
Install the rod in the control arm.
Slide the clevis clip on to each of the Golden
Clevis pins.
Repeat the above steps for the other three
ailerons.
7. You will need a Y-connector for the top aileron
servos. It will exit the fuselage through a hole
just to the inside of the front cabane strut. Use
cable ties to hold it to the cabane strut so the
plug is at the top on each side. You can then
plug the ailerons in and attach the top wing.
aileron plug
cable ties