Carl Goldberg GBGA1088 - Manual (Page 12)

12
2. Slide gear leg into slot on side of fuselage and
install retaining bolts through access holes on the side
and middle of fuselage. Be sure to use thread lock on
the bolts. The blind nuts are already installed.
Bolt access holes
1. Collect the following items.
(2) Landing gear legs
(6) 6-32X3/4” Socket head screws
(6) #6 flat washers
(2) Wheel pants, one left one right
(2) 4mm axles with lock nuts
(4) 4mm wheel collars
(2) 2-3/4” wheels
(2) 4-40 x t-nuts
(2) 4-40 x 1/2” socket head bolts.
Landing Gear Installation
3. Install each axle using the locking nut. Be
careful not to over tighten the nut, it looks like a large
bolt but it has been drilled out for the axle and can
be broken if too much torque is applied.
4. Install one wheel collar on each axle with
3/16” between the collar and the axle nut. This will
space the wheel in the center of the wheel pant.