Carl Goldberg GBGA1088 - Manual (Page 18)

18
FLYING WIRES
1. Locate the following parts
Roll of braided cable
(8) metal plates
(4) 2-56 rigging couplers
(4) golden clevis
(4) metal clevis retainers
(8) cable swages
(3) 2-56 x 1/2” screws
(3) 2-56 nuts
(3) #2 flat washers
(2) #2 x 1/2” sheet metal screws
2. Take the 8 flat plates and bend in the
middle to about a 30 degree angle.
3. Use the three 2-56 x 1/2” screws with a
washer under the head, and mount the brackets to
the fin and stab with the aircraft nut on the bottom.
The brackets go on each side of the fin and stab
with one bolt holding two on. There is a predrilled
hole at each location. Hold up to a light to help locate
the hole under the covering.
4. The other two brackets mount to the bottom
of the fuselage using the #2x1/2” sheet metal
screws. Mount to the tailwheel mounting block just in
front of the tailwheel bracket.