Carl Goldberg GBGA1088 - Manual (Page 24)

24
6. † If you use a Y-S engine that pressurizes the
tank, you should wrap the tank with nylon strapping
tape to make sure the pressure does not split the
tank. You should also put a couple of pieces across
the cap to make sure it does not blow out.
8. † Install the tank in the fuselage with the cap
aligned in the hole in the firewall. Use foam rubber
(not included) around the tank to hold it in place
7. † Before installing the tank, drill a 1/4” hole in
the firewall for the throttle pushrod to exit. The posi-
tion of the hole will depend on the engine you use.
Align the hole with the throttle arm on your engine.