ALTANA Micro-TRI-Gloss μ - Manual (Page 32)

31
English
Save 13
Select memory
All available areas of memory are
listed in this menu, beginning with
the one that is predefined.
The number of measurements
saved for each area in memory is
shown on the right.
Select the appropriate memory
area with the scroll wheel and
activate the selection by pressing
mode.
This automatically turns on Save
and switches the geometry if
necessary (if the selected memory
area is defined for other
geometries than what was
previously set).
Create memory
Users can set up their own
memory areas with this function.
Select the required geometry
before you activate this function.
Then you must enter the name of a
memory area. You can confirm the
suggested name directly with the
operate button or change it with
the scroll wheel. After you confirm,
Save is automatically turned on.