AERCO BMS 168 - Manual (Page 5)

Table of Contents
(Continued)
SECTION 5 PROGRAMMING THE BMS MODE OF OPERAT ION
5.1 INDOOR/OUTDOOR RESET MODE 5-1
5.1.1 Selecting Indoor/Outdoor Reset Mode 5-1
5.1.2 Entering System Start Temperature 5-1
5.1.3 Determining the Reset Schedule 5-1
5.1.4 Entering the Building Reference Temperature 5-2
5.1.5 Entering the Reset Ratio 5-2
5.2 SETUP FOR REMOTE SETPOINT MODE 5-2
5.2.1 Entering Header Set and Boiler Operating Modes 5-2
5.2.2 Entering Remote Signal Type and Header Temperature Limits 5-2
5.3 SETUP FOR CONSTANT SETPOINT MODE 5-3
5.3.1 Entering Header Set and Boiler Operating Mode 5-3
5.3.2 Entering Header Reference Temperature 5-3
5.4 CONFIGURING BOILERS FOR PULSE WIDTH MODULATION (PWM) 5-3
5.4.1 C-More Control System PWM Setup 5-4
5.4.2 Configuring the Temperature Controller 5-4
5.5 SYSTEM INITIALIZATION AND POLLING 5-4
5.6 TESTING THE SYSTEM 5-5
APPENDICES
Appendix A Specifications A-1
Appendix B Methods for Determining Reset Schedule
and Indoor/Outdoor Reset Ratio Charts B-1
Appendix C Normal (Read-Only) Mode Display Messages
and Defaults C-1
Appendix D Field Adjust Mode Display Messages and Defaults D-1
Appendix E Config Sys Mode Display Messages and Defaults E-1
Appendix F Sensor Resistance Data Sheet F-1
Appendix G Parts List G-1
Appendix H Troubleshooting H-1
Appendix I General BMS Wiring I-1
Appendix J Programming the BMS Using RS-232 Communication J-1
iii