Acura 2014 TL - Navigation Manual - Manual (Page 72)

Driving to Your Destination
Navigation System 71
Changing Your Destination
There are four methods by which you
can change or add a waypoint to your
route. These are:
Find Nearest (Voice command)
From the map screen, say one of the
“Find Nearest...” voice commands to
locate the nearest gas station, ATM,
restaurant or other point of interest. See
the “Find Nearest” voice commands
listing on page 145.
Go Home (Voice command)
From the map screen, say “Go Home
1” or “Go Home 2.” If an address has
been entered in both Home Address
1 and Home Address 2, say “Go
Home” and the system will give
preference to Home Address 1 and
display the confi rmation screen.
Using Interface Dial to Change
Destination
While following a calculated route, you
can select a new destination with the
map screen and the Interface Dial.
With the map screen displayed, use
the Interface Dial to move the cursor.
It will change to target mark. Use the
Interface Dial to position the target
mark on your desired new destination,
street, or icon, then push in on the
Interface Dial. The Select an item
screen or a pop-up menu may be
displayed if there are multiple POIs in
the vicinity.
NOTE:
The
Select an item screen will be
displayed when the target mark are
positioned near multiple icons or
locations. A pop-up menu will be
displayed when the target mark are
positioned on a particular street.
If this is not your desired new
destination, press the CANCEL button
or the BACK button to return to the
map screen. Reposition the target mark
with the Interface Dial, then push in
on the Interface Dial again to see the
new address.
When the Select an item screen is
displayed, select an item from the list,
and the Calculate route to screen is
displayed. Then select OK and push in
on the Interface Dial.