Acura 2014 TL - Navigation Manual - Manual (Page 100)

System Setup
Navigation System 99
After selecting the choice, a map
screen will be displayed.
Rotate the Interface Dial knob to
select the map scale (available scales
are 80, 200 and 400 metres scales). Use
the Interface Dial to move the target
mark (red circle) to the desired start
point and push in on the Interface
Dial to “set” the start point. Then
move the Interface Dial in a straight
or diagonal direction to encompass the
area to be avoided.
NOTE:
The maximum size of the “Avoid area”
is 800 metres in length or width.
The selected area will be displayed as a
shaded box with a yellow border. Push
in on the Interface Dial to set the end
point of the avoided area. To “redraw”
the area, select CANCEL and repeat
the area selection process.
Say or select OK to return to the Edit
avoid area screen.
If your selected area contains a
highway, the system will prompt you
with a pop-up box saying “Do you want
to avoid highways?” Answering “No”
allows you to enter a route through an
avoided area on a highway and skip the
“Avoid area caution box” (see Pop-ups
and Disclaimers on page 66 ).
When you return to the Edit avoid
area screen, the “Vicinity” fi eld is
automatically fi lled in by the system.
Re-edit the area “Name” if desired.
Select OK on the Edit avoid area screen
to fi nish editing. Your new avoided area
will now appear on the “Avoid area” list
and be viewable on the map screen.
NOTE:
You can select areas to avoid, however
you cannot select roads or areas that
you want the system to use for routing.