Acura 2014 TL - Navigation Manual - Manual (Page 107)

System Setup
106 Navigation System
Switching Display Mode Automatically
llumination control Operation But remember
Display Mode button (see page
10)
Allows selection of Day, Night or Off display
mode. This button has the highest priority and
overrides all other display control adjustments
listed below. When the car is restarted, the display mode
previously selected by this button is canceled
and is determined by one of the controls below.
Sunlight sensor (middle of dash near
the windshield, see the vehicle Owner’s
manual for location) If the sunlight sensor detects daylight and
the headlights are turned on, the system
automatically overrides (cancels) the Night
display and displays the Day display mode.
If desired, use the Display Mode button
to override this automatic choice.
Dash illumination adjustment knob
(see the vehicle Owner’s manual for
location) When headlights are turned on, and you wish
to have the Day display mode, then adjust the
illumination to the full bright setting (beeps). Remember to adjust the dash brightness back to
mid-range to allow auto switching by sensing
whether the headlights are on or off.
Headlights (Auto/On/Off) When turned on, the display changes to Night
display mode. The previous two controls listed
above can cancel this function. Use the Display Mode button, or, with
the headlights on, adjust the dash illumination
to full bright to set the display to your desired
choice.
Map Day/Night screen colour choice
(see page 104 for the Day and Night
colour choices) The user can select the colour of the screen that
will be displayed for the Day and Night display
modes. For best contrast, ensure that the map colour is
white for Day and black for Night.
Recommended Display Mode Day/Night settings:
• With the headlights on, select mid-range for the dash illumination (see the vehicle Owner’s manual for location of knob).
• With the headlights off, select mid-range for the dash illumination (see the vehicle Owner’s manual for location of knob).
• On the SET UP “Colour” adjustment screen, choose white for the map Day display and black for the map Night display
(see page 104 ). Inappropriate adjustment of these colours can cause the Day/Night modes to appear inoperative.
NOTE:
See the vehicle Owner’s manual for additional information regarding the dash brightness adjustment.