Acura 2014 TL - Navigation Manual - Manual (Page 42)

Entering a Destination
Navigation System 41
By Map Input
After you select Map Input from the
DEST screen (Dest. MENU 2), the
display changes to:
Select Current Position, City,
Province, or USA, Canada and
Mexico to display the map.
NOTE:
• Prior to departure, you can set areas
to avoid. The system then includes
them in its calculations for the
destination you have entered. See
Edit Avoid Area on page 98 .
• For information on the available
voice commands, see Voice
Command Index on page 143 .
Showing the Map of Current
Position
The Current Position selection
assumes that you are looking for a
destination in the immediate area. The
display changes to:
The red arrow indicates your vehicle
position. Find your desired destination
by moving the Interface Dial up and
down and to the left and right. The map
and target mark will move in the same
direction.
The yellow box indicates the area you
will see when you click on the current
map with the Interface Dial. The
scale will decrease each time you push
in the Interface Dial.
If desired, rotate the Interface Dial
knob to change the map scale. When
you have the target mark on the desired
icon, polygon, or road, push in on the
Interface Dial. The address of the
location will appear at the top of the
screen (at scales less than 1 mile).
NOTE:
Information icons are displayed at
scales from 1,6 kilometres to 400
metres, POI icons are displayed at
200 metres mile or less, and roads are
displayed at 400 metres or less.
If this is the desired address, push in
on the Interface Dial again. If not,
use the Interface Dial to reposition
the target mark, then push in on the
Interface Dial again to display the
new address.