Cabletron Systems WPIM-RT1 - Manual (Page 47)

WPIM-RT1 User’s Guide B-1
APPENDIX B
FCC PART 68 - USER’S INFORMATION
The following instructions are provided to ensure compliance with the
Federal Communications Commission (FCC) Rules, Part 68.
1. This device must only be connected to the ISDN Basic Rate network
behind an FCC Part 68 registered channel service unit. Direct
connection is not allowed.
a. All direct connections to T1 lines must be made using standard
plugs and jacks.
b. All direct connections to DDS lines must be made using standard
plugs and jacks.
2. Before connecting your unit, you must inform the telephone company
of the following information:
3. If the unit appears to be malfunctioning, it should be disconnected
from the telephone lines until you learn if your equipment or the
telephone line is the source of the trouble. If your equipment needs
repair, it should not be reconnected until it is repaired.
4. If the telephone company finds that the equipment is exceeding
tolerable parameters, the telephone company can temporarily
disconnect service, although they will attempt to give you advance
notice if possible.
Port ID REN/SOC FIC USOC
WPIM-RT1 6.0N 04DU9-BN
04DU9-DN
04DU9-1KN
04DU9-1SN
04DU9-1ZN RJ48C