Cabletron Systems WPIM-RT1 - Manual (Page 23)

WPIM-RT1 User’s Guide 3-1
CHAPTER 3
LOCAL MANAGEMENT
This chapter explains how to configure the WPIM-RT1 through Local
Management for T1 service on the CSX400 or the HSIM-W6. Refer to
the Cabletron Systems HSIM-SSA710 User’s Guide for information on
Local Management for the HSIM-SSA710.
The WAN Physical Configuration screen and the WAN Interface
Configuration screen appear as Local Management menu selections
when you install the WPIM-RT1 into a host module. Refer to the host
platform User’s Guide for instructions about how to set up and access
Local Management.
Sections of this chapter include:
• The WAN Physical Configuration screen, Section 3.1
• The WAN Interface Configuration screen, Section 3.2
• Full T1 Configuration using PPP (Point-to-Point Protocol),
Section 3.3
• Fractional T1 Configuration using PPP, Section 3.4
• Frame Relay Configuration, Section 3.5
Read Section 3.1 and Section 3.2 to gain an understanding of the
WPIM-RT1 Local Management screens for T1. Section 3.3 through
Section 3.5 provide examples for setting up the WPIM-RT1 for full or
fractional T1 in a PPP environment, or for configuring the WPIM-RT1 for
Frame Relay in the T1 mode.
TIP
Navigate through the WPIM Local Management Screens by
using the following keyboard commands:
Arrow keys to move up, down, right or left within the screen.
SPACE bar to toggle between selections in a field.
ENTER (RETURN) to implement a selection.