Cabletron Systems WPIM-RT1 - Manual (Page 17)

WPIM-RT1 User’s Guide 2-1
CHAPTER 2
SETUP AND INSTALLATION
The following information in this chapter details the set up and
installation of the WPIM-RT1 into a host platform.
2.1 INSTALLING THE WPIM-RT1
Figure 2-1 WPIM-RT1
For additional support related to the WPIM-RT1, refer to the host
platform manual into which the WPIM-RT1 is being installed. Locate the
guide by clicking on the Cabletron Systems QuickSET program group
icon after installing the QuickSET CD on your computer, or see
Related
Manuals in the Introduction .
Only qualified personnel should install the WPIM-RT1. This
User’s Guide is intended for the experienced network
equipment installer.
NOTE
QuickSET or Local Management must be used to set up the
WPIM-RT1 in management before any connections are made
to the WAN. Follow the directions in this chapter carefully in
order to connect the WAN cable at the proper time.
NOTE
Some WPIMs require version 1.02 or greater of QuickSET to
participate and function correctly in your network. Contact
Cabletron Systems to obtain the latest version of QuickSET.
The information in this note does not apply if the WPIM-RT1 is
being installed into the HSIM-SSA710. Please refer to the
documentation for the HSIM-SSA710 if the WPIM-RT1 is being
installed in an HSIM-SSA710.
WPIM-RT1
27502