KEYENCE CV-X Series - Manual (Page 6)

KEYENCE CORPORATION. Vision System Division ‐ 6 ‐ www.keyence.com
2
1
2. Outputting the Measured Value/Judged Value
(PLC-Link) [MELSEC FX Series]
✎
Configuring the Output Settings
Press "Select Data", and select the target data to output.
Open "Output Settings", and select "PLC- Link".
3
After finishing adding data, press "OK". Check the data to output and the data memory address.
Set the measured values/judged values to output in "Output Settings". This section describes how to assign tool measurement
values/judgment values.
(In the description, the following are output: 1: Total Status Value, 2: T100: Pattern Search. Pattern X Position Result, 3: T100:
Pattern Search. Pattern XY Position Result, 4: T101: Area. Area Result, 5: T102: OCR. Recognized Character (String), 6: T100:
Pattern Search. Judged Value, 7: T101: Area. Judged Value, 8: Program Time, 9: Total Count)
When added, the result output unit opens.
The added output data and the list of
data memory address to which the data
is output are displayed.
The start of the data memory address is
specified in "Result Output Address" in
[Global] > [Communications & I/O] >
[PLC‐Link] (Data memory 500 in the
above example).
See the next page for the output format
when storing in the data memory.
Items that can be output are categorized
into "Measured Value", "Judged Value",
and "Variables".
Select an item to output from these
categories and press "Add" to add the
item.
You can change the output order of the
added items, or delete the items.