Holtgreven Ohaus Defender Series Bench Scales - Manual (Page 69)

7000 Series Indicators EN-67
8.4 Compliance
Compliance to the following standards is indicated by the corresponding marking on the product.
Marking Standard
This product conforms to the EMC Directive 2004/108/EC, the Low Voltage Directive 2006/95/EC and the Non-
automatic Weighing Instrument Directive 90/384/EEC.
The complete Declaration of Conformity is available from Ohaus Corporation.
UL60950-1:2003
AS/NZS4251.1, AS/NZS4252.1
EC Emissions Note
This device complies with EN55011/CISPR 11 Class B Group 1.
FCC Note
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in
a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and
used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the
interference at his own expense.
Industry Canada Note
This Class B digital apparatus complies with Canadian ICES-003.
ISO 9001 Registration
In 1994, Ohaus Corporation, USA, was awarded a certificate of registration to ISO 9001 by Bureau Veritus Quality International
(BVQI), confirming that the Ohaus quality management system is compliant with the ISO 9001 standard’s requirements. On May
15, 2003, Ohaus Corporation, USA, was re-registered to the ISO 9001:2000 standard.
Important Notice for verified weighing instruments
Important notice for verified weighing instruments
Weighing Instruments verified at the place of manufacture bear one of the preceding mark on the packing label
and the green ‘M’ (metrology) sticker on the descriptive plate. They may be put into service immediately.
Weighing Instruments to be verified in two stages have no green ‘M’ (metrology) on the descriptive plate and
bear one of the preceding identification mark on the packing label. The second stage of the initial verification
must be carried out by the approved service organization of the authorized representative within the EC or by the
national weight & measures (W+M) authorities.
The first stage of the initial verification has been carried out at the manufacturers work. It comprises all tests
according to the adopted European standard EN 45501:1992, paragraph 8.2.2.
If national regulations limit the validity period of the verification, the user of the weighing instrument must strictly
observe the re-verification period and inform the respective W+M authorities.