Comm 1, Stop, Handsh – Holtgreven Ohaus Defender Series Bench Scales User Manual
Page 39: Comm 2, Addres, Alt.cmm, Print, Tare

7000 Series Indicators EN-37
COmM 1
STOP BITS
2
StOP
1
HARDWARE
COmM 1
HANDSHAKE
XON-XOFF
HANdSH
NONE
99
COmM 2
ADDRESS
01
AddrES
OFF
COmM 1
ALT COMMAND
ALt.CmM
Z
A
ALt.CmM
TARE
Z
tArE
A
3.10.4 Stop Bit
Set the number of stop bits.
1
= 1 stop bit
2
= 2 stop bits
3.10.5 Handshake
Set the flow control method.
NONE
= no handshaking
XON-XOFF =
XON/XOFF
handshaking
HARDWARE
= hardware handshaking (COM1 menu only)
3.10.6 Address
Set the communication address (COM2 menu only).
OFF
= no address
01 to 99
= address 01 to 99
NOTE: The Address menu item is only displayed in the COM2 menu if the optional RS485/RS422 PC
Board is installed.
3.10.7 Alternate Command Sub-menu
Enter this sub-menu to set a different command character for the P (Print), T (Tare) or Z (Zero)
commands.
NOTE: The selected character can only be used for one command.
Alternate Print Command
Set the alternate command character for Print.
Settings of A to Z are available. The default setting is
P.
Alternate Tare Command
Set the alternate command character for Tare.
Settings of A to Z are available. The default setting is
T.