Holtgreven Ohaus Defender Series Bench Scales - Manual (Page 47)

7000 Series Indicators EN-45
-Off-
*
0.002
kg
*
NET
0.000
kg
*
NET
-1.000
kg
PT
*
NET
0.000
kg
*
1.000
kg
*
0
0.000
kg
*
1.000
kg
*
0
0.000
kg
*
0
0.000
lb
*
0
0.000
kg
05:20 P
4. OPERATION
4.1 Turning Indicator On/Off
To turn the indicator on, press the ON/ZERO Off button. The indicator performs a display test
followed by a series of informational displays, and then enters the last active mode.
To turn the indicator off, press and hold the
ON/ZERO Off button until -OFF- is displayed.
If powered by AC mains, the indicator enters standby and displays the clock.
If powered by batteries, the indicator turns off completely.
4.2 Zero Operation
Press the ON/ZERO Off button to zero the display.
NOTE: The display must be stable and within the Zero Range.
4.3 Manual Tare
Place the container on the scale and press the TARE button.
NOTE: The display must be stable.
To clear the tare, remove all weight from the scale and press the
TARE button.
4.4 Preset Tare
Enter the preset tare value using the numeric keypad, then press the TARE button. The display will
show the PT symbol and the tare value as a negative number.
To clear the preset tare, remove all weight from the scale and press the
TARE button.
NOTE: The preset tare value may also be entered or cleared using the xT command. Refer to Section
5.1.
4.5 Auto Tare
When Auto Tare is set ON in the Setup menu, the initial item placed on the scale is automatically
tared.
The tare value is automatically cleared when the weight on the scale is fully removed.
4.6 Changing Units of Measure
Press and hold the Units button until the desired unit of measure is displayed, then release the
button.
NOTE: Only units of measure enabled in the Unit menu will be displayed. Refer to Section 3.7.