FRITSCH PULVERISETTE 13 premium line - Manual (Page 22)

5 Initial start-up
The disk mill is delivered with a mounted grinding disk. Check the gap
width before the first grinding. (See Ä Chapter 6.4 ‘Setting the gap
width’ on page 27). After the disk mill has been set up as described in
Ä Chapter 4.3 ‘Setting up’ on page 18 and the mains plug has been
plugged into the mains socket, the device is ready for operation.
Switch on the device only after all work described from Ä Chapter 4
‘Installation’ on page 18 has been carried out.
CAUTION!
– Grinding disks must not touch each other.
– The device may be operated only when the grinding
disks have been mounted and fixated.
– Smallest gap width 0.05 mm
5.1 Switching on
Switch main switch (3) to I. The display (1) switches on and the Stop
button (f) lights up red. If the grinding chamber is locked, the unlocking/
locking button (h) lights up green.
5.2 Function check
Once the grinding chamber is closed and the grinding stock container is
inserted, the device can be started by the Start button (e). The disk mill
starts up. Press the Stop button (f) then and the machine comes to a
stop. Continue with Ä Chapter 6 ‘Using the device’ on page 23.
5.3 Switching off
Switch main switch (3) to 0. The device switches off completely.
Initial start-up
- 22 -