Elektron Monomachine - Manual (Page 99)

GLOBAL SETTINGS
91
PROGRAM CHANGE can be disabled for MIDI input and output. See section “CONTROL
OUT2”, on page 92 for more information.
The Monomachine SFX-6 joystick sends pitch-bend for right and left directions, CTRL
CHANGE 1 (mod wheel) for the upward direction and CTRL CHANGE 2 (breath control) for
the downward direction. The same messages are accepted by the Monomachine tabletop
versions as joystick control.
• If the individual track channel is disabled you can still control the individual track
parameters using the NRPN interface.
CONTROL OUT1
This menu contains parameters that control how the Monomachine sends MIDI note and
control data.
1. Select the CONTROL in the GLOBAL menu. Then select CONTROL OUT1 using the
[ARROW] keys and press [ENTER/YES].
Navigate between the parameters using the [UP] and [DOWN] keys. Change the parame-
ter values using [LEFT] and [RIGHT].
SEQUENCER controls whether MIDI data of the sequencer should be sent to the internal
synthesizer tracks, MIDI OUT or both.
ARP controls whether MIDI data of the arpeggiator should be sent to the internal synthe-
sizer tracks, MIDI OUT or both.
KEYBOARD controls whether MIDI data of the keyboard and joystick (SFX-6 only) should
be sent to the internal synthesizer tracks, MIDI OUT or both. The keyboard on the Mon-
omachine tabletop versions is represented by the [TRIG] buttons when not in the GRID
RECORDING or LIVE RECORDING modes.
The available selections for all the parameters are:
• INT - Only internal control, no external MIDI data will be sent.
• OUT - No internal control, only external MIDI data will be sent.
• INT+OUT - Internal control, and MIDI data will be sent.
• Parameter locks of the internal tracks are not transmitted over MIDI, because the
data transfer rate of the MIDI standard is too low for delivering large number of
control data in time.