Doepfer Wheel Electronic - Manual (Page 3)

User's Guide Wheel Electronic V1.0 Page 3
Warranty
• Applying any negative voltage (< 0V) or positive voltage above +5V (> +5V) to one of the
five inputs ST1…ST5 will destroy the circuit !
• If potentiometers and/or switches are connected between GND and +5V of WE as
described in this manual no problems will occur.
• When external control voltages are connected to WE the user has to pay attention that the
voltages applied are strictly within GND and +5V referenced to GND of WE !
• Do not solder directly to any of the pin headers but use cable sets with suitable female
connectors to make the connections between WE and the potentiometers, switches,
voltages or other parts. A cable set that contains all required connectors and cables is
included with WE.
• Carry out all connections in the off-state of WE (i.e. when powered-off only) !
• Do not power on WE (i.e. do not connect the power supply to the corresponding jack
socket) before all five inputs ST1…ST5 are connected. Do not leave analog inputs
unconnected ! Unused inputs have to be connected or jumpered to GND or +5V.
• WE electronics is an electrostatic sensitive device. Avoid any electrostatic charges ! Do not
touch any of the inputs with your fingers !
• Avoid short circuits !
• Ignoring any of these items will cause warranty loss !
• Return of the WE within the 2 weeks return time limit (valid only in Germany) is only
possible if all these items have been met. Return of used cable sets is not possible. We also
cannot take back modules that have been soldered by the user.