Cub Cadet ZT-3400 - Manual (Page 34)

32 ZT-2800 ® /ZT-3100™/ZT-3400™
BraKe asseMBLY (Code 1 or 2) (ZT-2800/ZT-3100)
Refer to Figure 27
disassembly
1. Remove the center section per detail on
page 31.
NOTE: Take note of the orientation of the brake
cam (101) and the brake puck (100).
2. Remove the brake (cam) shaft (101) and
the brake puck (100).
3. Remove the O-rings (10) from the brake
(cam) shaft (101) and discard.
inspection
1. Inspect all components for unusual wear or
damage.
assembly
1. Install the new O-rings (10) onto the brake
(cam) shaft (101).
NOTE: Apply a thin coating of oil to the O-rings
before installing.
To protect the O-rings from possible
damage during installation, apply a
protective covering over the splines of
the brake cam (e.g., cellophane, tape,
etc.).
2. Place the brake puck (100) onto the brake
(cam) shaft (101). Install the brake cam kit
(208) in center section.
figure 27, Brake Cam Kit
Character #7 in the model number code = 1
or 2.
Example: ZX-XXXX-1XXX-XXXX
100
101
10
10
Center Section